DS1825U+T&R【PDF 4/21 页】IC THERMOMETER DIGITAL 8-USOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录39

1页 2页 3页 [4页]5页 6页 7页 8页

DS1825 Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID

4 of 21

OVERVIEW

Figure 1 shows a block diagram of the DS1825, and pin descriptions are given in Table 1. The 64-bit ROM stores

the devices unique serial code. The scratchpad memory contains the 2-byte temperature register that stores the

digital output from the temperature sensor. In addition, the scratchpad provides access to the 1-byte upper and

lower alarm trigger registers (T

and T

), and the 1-byte configuration register. The configuration register allows the

user to set the resolution of the temperature-to-digital conversion to 9, 10, 11, or 12 bits. It is also used for the hard-

wired address programmed by the AD0-AD3 pins. The T

, T

, and configuration

registers are NV (EEPROM), so

they will retain data when the device is powered down.

The DS1825 uses Dallas exclusive 1-Wire bus protocol that implements bus communication using one control

signal. The control line requires a weak pullup resistor since all devices are linked to the bus through a 3-state or

open-drain port (the DQ pin in the case of the DS1825). In this bus system, the microprocessor (the master device)

identifies and addresses devices on the bus using each devices unique 64-bit code. Because each device has a

unique code, the number of devices that can be addressed on one bus is virtually unlimited. The 1-Wire bus

protocol, including detailed explanations of the commands and time slots, is covered in the 1-Wire BUS SYSTEM

section of this data sheet.

Another feature of the DS1825 is the ability to operate without an external power supply. Power is instead supplied

through the 1-Wire pullup resistor through the DQ pin when the bus is high. The high bus signal also charges an

internal capacitor (C

), which then supplies power to the device when the bus is low. This method of deriving

power from the 1-Wire bus is referred to as parasite power. As an alternative, the DS1825 can also be powered

by an external supply on V

Figure 1. DS1825 BLOCK DIAGRAM

Power

Supply

Sense

64-Bit ROM

And

1-wire Port

16-bit Temp Reg

8-bit TH Register

8-bit TL Register

8-bit Config. Reg

8-bit CRC Gen

Memory

Control Logic

VDD

GND

VPULLUP

AD0-AD3

4.7k

Parasite

Power

Circuit

Cpp

Address Pin

Input Latch

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式